| SPECIFICATIONS | |
| Aruba 2530-8G-PoE+ Switch (J9774A) | |
| I/O ports and slots | |
| 8 RJ-45 autosensing 10/100/1000 PoE+ ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type
100BASE-TX, IEEE 802.3ab Type 1000BASE-T, IEEE 802.3at PoE+); Media Type: Auto-MDIX; Duplex: 10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only 2 dual-personality ports; each port can be used as either an RJ-45 10/100/1000 port (IEEE 802.3 Type 10Base-T; IEEE 802.3u Type 100Base- Tx; IEEE 802.3ab1000Base-T Gigabit Ethernet) or as a SFP slot (for use with SFP transceivers) |
|
| Additional ports and slots | |
| 1 dual-personality (RJ-45 or USB micro-B) serial console port | |
| Physical characteristics | |
| Dimensions | 10.00(w) x 6.28(d) x 1.75(h) in (25.4 x 15.95 x 4.45 cm)
(1U height) |
| Weight | 2.2 lb (1 kg) |
| Memory and processor | |
| ARM9E @ 800 MHz, 128 MB flash;
Packet buffer size: 1.5 MB dynamically allocated, 256 MB DDR3 DIMM |
|
| Mounting and enclosure | |
| Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-mounting kit available); Horizontal surface mounting;
Wall mountin |
|
| Performance | |
| IPv6 Ready Certified | |
| 100 Mb Latency | < 7.4 µs (LIFO 64-byte packets) |
| 1000 Mb Latency | < 2.6 µs (LIFO 64-byte packets) |
| Throughput | up to 14.8 Mpps (64-byte packets) |
| Switching capacity | 20 Gbps |
| MAC address table size | 16000 entries |
| Environment | |
| Operating temperature | 32°F to 113°F (0°C to 45°C) |
| Operating relative humidity | 15% to 95% @ 104°F (40°C),
noncondensing |
| Nonoperating/Storage temperature | -40°F to 158°F (-40°C to 70°C) |
| Nonoperating/Storage relative humidity | 15% to 90% @ 149°F (65°C),
noncondensing |
| Altitude | up to 10,000 ft (3 km) |
| Acoustic | Power: 0 dB, Pressure: 0 dB |
| Electrical characteristics | |
| Frequency | 50/60 Hz |
| Maximum heat dissipation | 65 BTU/hr (68.58 kJ/hr), (switch only: 65 BTU/hr; combined switch + max. PoE devices: 293 BTU/hr) |
| Voltage | 100 – 127/200 – 240 VAC, rated
(depending on power supply chosen) |
| Current | 1.4 A |
| Maximum power rating | 86 W |
| Idle power | 13.4 W |
| PoE power | 67 W |
| Notes | Idle power is the actual power consumption of the device with no ports connected.
Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. PoE power is the total power bud- get available to all PoE ports. |
| Safety | |
| UL 60950-1; CAN/CSA 22.2 No.
60950-1; EN 60825; IEC 60950-1; EN 60950-1 |
|
| Emissions | |
| FCC Class A; EN 55022/CISPR-22
Class A; VCCI Class A |
|
| Immunity | |
| Generic | EN 55024, CISPR 24 |
| EN | EN 55024, CISPR 24 |
| ESD | IEC 61000-4-2 |
| Radiated | IEC 61000-4-3 |
| EFT/Burst | IEC 61000-4-4 |
| Surge | IEC 61000-4-5 |
| Conducted | IEC 61000-4-6 |
| Power frequency magnetic field | IEC 61000-4-8 |
| Voltage dips and interruptions | IEC 61000-4-11 |
| Harmonics | EN 61000-3-2, IEC 61000-3-2 |
| Flicker | EN 61000-3-3, IEC 61000-3-3 |
| Management | |
| Aruba AirWave Network Manage- ment; IMC– Intelligent Management Center; Command-line interface; Web browser; Configuration menu; Out-of-band management (serial RS-232c or micro usb); IEEE 802.3 Ethernet mib; Repeater mib; Ethernet interface mib | |
| Notes | |
| IEEE 802.3az applies to Gigabit models only; IEEE 802.3at and IEEE 802.3af apply to PoE+ models only. When using SFPs with this product, SFPs with revision “B” or later (product number ends with the letter “B” or later, e.g., J4858B, J4859C) are required. | |
| Services | |
| Refer to the Hewlett Packard Enterprise website at www.hpe.com/networking/services for details on the service-level descriptions and product numbers. For details about services and response times in your area, please contact your local Hewlett Packard Enterprise sales office. | |


Hãy là người đầu tiên nhận xét “ARUBA 2530-8G-POE+ SWITCH (J9774A)”
You must be logged in to post a review.