SPECIFICATIONS | |
Aruba 2530-8G Switch (J9777A) | |
I/O ports and slots | |
8 RJ-45 autosensing 10/100/1000 ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T);
Media Type: Auto-MDIX; Duplex: 10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only 2 dual-personality ports; each port can be used as either an RJ-45 10/100/1000 port (IEEE 802.3 Type 10Base-T; IEEE 802.3u Type 100Base-Tx; IEEE 802.3ab 1000Base-T Gigabit Ethernet) or as a SFP slot (for use with SFP transceivers) ports |
|
Additional ports and slots | |
1 dual-personality (RJ-45 or USB micro-B) serial console port | |
Physical characteristics | |
Dimensions | 10.00 (w) x 6.28 (d) x 1.75 (h) in
(25.4 x 15.95 x 4.45 cm) (1U height) |
Weight | 2.0 lb (0.91 kg) |
Memory and processor | |
ARM9E @ 800 MHz, 128 MB flash;
Packet buffer size: 1.5 MB dynamically allocated, 256 MB DDR3 DIMM |
|
Mounting and enclosure | |
Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-mounting kit available); Horizontal surface mounting;
Wall mounting |
|
Performance | |
IPv6 Ready Certified | |
100 Mb Latency | < 7.4 µs (LIFO 64-byte packets) |
1000 Mb Latency | < 2.6 µs (LIFO 64-byte packets) |
Throughput | up to 14.8 Mpps (64-byte packets) |
Switching capacity | 20 Gbps |
MAC address table size | 16000 entries |
Environment | |
Operating temperature | 32°F to 113°F (0°C to 45°C) |
Operating relative humidity | 15% to 95% @ 104°F (40°C),
noncondensing |
Nonoperating/Storage temperature | -40°F to 158°F (-40°C to 70°C) |
Nonoperating/Storage relative humidity | 15% to 90% @ 149°F (65°C),
noncondensing |
Altitude | up to 10,000 ft (3 km) |
Acoustic | Power: 0 dB, Pressure: 0 dB |
Electrical characteristics | |
Frequency | 50/60 Hz |
Maximum heat dissipation | 63 BTU/hr (66.46 kJ/hr), (switch only:
63 BTU/hr) |
Voltage | 100 – 127/200 – 240 VAC, rated
(depending on power supply chosen) |
Current | 0.5 A |
Maximum power rating | 18.6 W |
Idle power | 13.6 W |
Notes | Idle power is the actual power consumption of the device with no ports connected.
Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. |
Safety | |
UL 60950-1; CAN/CSA 22.2 No.
60950-1; EN 60825; IEC 60950-1; EN 60950-1 |
|
Emissions | |
FCC Class A; EN 55022/CISPR-22
Class A; VCCI Class A |
Immunity | |
Generic | EN 55024, CISPR 24 |
EN | EN 55024, CISPR 24 |
ESD | IEC 61000-4-2 |
Radiated | IEC 61000-4-3 |
EFT/Burst | IEC 61000-4-4 |
Surge | IEC 61000-4-5 |
Conducted | IEC 61000-4-6 |
Power frequency magnetic field | IEC 61000-4-8 |
Voltage dips and interruptions | IEC 61000-4-11 |
Harmonics | EN 61000-3-2, IEC 61000-3-2 |
Flicker | EN 61000-3-3, IEC 61000-3-3 |
Management | |
Aruba AirWave Network Manage- ment; IMC – Intelligent Management Center; Command-line interface; Web browser; Configuration menu; Out-of-band management (serial
RS-232c or micro usb); IEEE 802.3 Ethernet mib; Repeater mib; Ethernet interface mib |
|
Notes | |
IEEE 802.3az applies to Gigabit models only; IEEE 802.3at and IEEE 802.3af apply to PoE+ models only. When using SFPs with this product, SFPs with revision “B” or later (product number ends with the letter “B” or later, e.g., J4858B, J4859C) are required. | |
Services | |
Refer to the Hewlett Packard Enterprise website at www.hpe.com/networking/services for details on the service-level descriptions and product numbers. For details about services and response times in your area, please contact your local Hewlett Packard Enterprise sales office. |
Be the first to review “ARUBA 2530-8G SWITCH (J9777A)”
You must be logged in to post a review.